Figure 51. Drive removal
Step 2. Grasp the handle and pull the drive out of the drive bay.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a 2.5-inch hot-swap drive
Use this procedure to install a 2.5-inch drive.
Following are the types of drives supported by this server:
• NVMe solid-state drive
• SATA/SAS solid-state drive
• SATA/SAS hard-disk drive
For a complete list of supported optional device for this server, see
http://www.lenovo.com/us/en/
serverproven/
.
Before installing a 2.5-inch hot-swap drive:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 59).
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To install a 2.5-inch drive, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/watch?v=pIb0bIyfkDY&=PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
• Youku: http://v.youku.com/v_show/id_XMzMyODU3NTY2NA==.html?spm=a2hzp.8253876.0.0&f=51276390
Step 1. If new drives are to be added, see “Install a 2.5-inch drive” in ThinkSystem SR860 Setup Guide to
determine available drive bays to the new drives.
Step 2. Gently rotate the release latch away to unlock the drive handle.
Step 3. Slide the drive into the drive bay, and push it until it stops.
64
ThinkSystem SR860 Maintenance Manual
To Next Page
Loading...
