Figure 74. M.2 backplane removal
To remove an M.2 drive from the M.2 backplane, see “Remove an M.2 drive from the M.2 backplane” on
page 87.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the M.2 backplane
Use this procedure to install the M.2 backplane.
Before installing the M.2 backplane:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 59).
2. Install an M.2 drive to every available connector on the M.2 backplane (see “Install an M.2 drive in the
M.2 backplane” on page 87).
3. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
4. Disconnect the USB 3.0 cable of operator panel tray assembly, and remove it vertically from the system
board.
Chapter 3. Hardware replacement procedures 85
To Next Page
Loading...
