6. To install a new 2.5-inch storage drive, do the following:
a. Slide the 3.5-inch storage-drive bracket out of the rear of the enclosure.
b. Flex the sides of the bracket to remove the storage-drive converter from the bracket.
c. Install a new 2.5-inch storage drive into the storage-drive converter. Then install the four screws to
secure the new storage drive to the storage-drive converter.
Figure 78. Installing the new solid-state drive into the storage converter
d. To install the storage-drive converter into the 3.5-inch storage-drive bracket, flex the bracket and
align pin
1 , pin 2 , pin 3 , and pin 4 on the bracket with the corresponding holes in the storage
converter.
Figure 79. Installing the storage converter together with the solid-state drive into the storage drive bracket
130 P330 Hardware Maintenance Manual
To Next Page
Loading...
