Type-2 storage-drive cage
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 “Read this first: Important safety information” on page 1.
Some computer models come with a type-2 storage-drive cage for installing or replacing a 2.5-inch storage
drive.
To replace the 2.5-inch storage drive, do the following:
1. Prepare your computer. See “Preparing your computer” on page 98.
2. Locate the type-2 storage-drive cage. See “Computer components” on page 33.
3. To remove a 2.5-inch storage drive from the type-2 storage-drive cage, do the following:
a. Disconnect the signal cable and the power cable from the 2.5-inch storage drive.
b. Remove the screw and slide the type-2 storage-drive cage downward to release it from the drive bay
assembly.
Figure 109. Removing the type-2 storage-drive cage
c. Pull the handle of the plastic 2.5-inch storage-drive bracket to remove it from the type-2 storage-
drive cage.
Figure 110. Removing the 2.5-inch storage drive
d. Flex the sides of the bracket to remove the storage drive from the bracket.
4. To install a new 2.5-inch storage drive into the type-2 storage-drive cage, do the following:
148
P330 Hardware Maintenance Manual
To Next Page
Loading...
