Lenze 8200 motec Series - Important controller codes

Commissioning
Important controller codes
6

105
EDK82MV752 DE/EN/FR 7.2
6.6 Important controller codes
 Note!
ƒ The following table describes in detail the codes mentioned in the examples
for commissioning!
ƒ Do not change codes, the meaning of which is unknown to you! All codes
are described in detail in the System Manual.
How to read the code table
Column Abbreviation Meaning
Code
Cxxxx Code Cxxxx
l The parameter value of the code can be defined
differently within each parameter set
l The parameter value is accepted immediately
(ONLINE)
1 Subcode 1 of Cxxxx
2 Subcode 2 of Cxxxx
* Parameter value of the code is the same for all parameter sets and can be
changed in parameter set 1
#
Keypad E82ZBC Changed parameter of the code or subcode will be
accepted after pressing #
Keypad XT EMZ9371BC Changed parameter of the code or subcode will be
accepted after pressing $)%
&
Keypad E82ZBC Changed parameter of the code or subcode will be
accepted after pressing # if the controller is
inhibited
Keypad XT EMZ9371BC Changed parameter of the code or subcode will be
accepted after pressing $)% if the controller is
inhibited
(A) Code, subcode or selection only available for operation with application I/O
uSEr Code is contained in the Lenze setting in the USER menu
Designation Name of the code
Lenze Lenze setting (value at delivery or after restoring the delivery status with C0002)
à Further information can be obtained from the "IMPORTANT" column
Selection 1 {%} 99 Min. value {unit}max. value
IMPORTANT − Brief, important explanations