Technical Data
BA8230 49
2.7.2.1 Terminal strip wiring :X15
and signal functions
Terminal :X15 Function Comments
1)
:1 DC +24 V Max. load: 800 mA
:2 DC 0 V Reference potential for DC +24 V
:3 PTC- Motor thermistor connection
:4 Motor temperature Motor thermistor connection
Binary inputs
:5 ON / STOP
Flank LOW • HIGH = ON
:6 MANUAL/AUTOMATIC +24 V = Automatic; Open = Manual
:7 STOP
Flank HIGH • LOW = STOP
:8 FAST STOP Open = Fast Stop
:9 LEFT +24 V = Left
:10 INHIBIT Open = Inhibit, drive idles down
:11 RIGHT +24 V = Right
:12 EXTERNAL ERROR Open = Inverter disabled
:13 QUIT Flank LOW ® HIGH = acknowledge
:14 DIGITAL INPUT 1 Function available
:15 DIGITAL INPUT 2 Function available
:16 DIGITAL INPUT 3 Function available
Binary outputs
:17 Relay DC 30 V; 0,5 A max.
:18 contact closed on "READY"
2)
:19 Relay DC 30 V; 0,5 A max.
:20 contact closed on "ON"
:21 Relay DC 30 V; 0,5 A max.
:22 contact
2)
closed on "ERROR"
3)
:23 Relay DC 30 V; 0,5 A max.
:24 contact
2)
Function available
Standard: "SPEED REACHED"
3),4)
:25 DC +24 V parallel to terminal 1
:26 DC 0 V parallel to terminal 2
Demand inputs Analog outputs
:27 MAIN DEMAND (-) Differential input
:28 MAIN DEMAND (+) Differential input
:29 ADDIT. DEMAND (-) Differential input
:30 ADDIT. DEMAND (+) Differential input
:31 DC +10 V Rating: 20 mA resistant to short
circuit
:32 DC -10 V Rating: 20 mA resistant to short
circuit
:33 A-OUTPUT 1 Rating: 3 mA
:34 DC 0 V Reference potential 0 V for DC + 10 V
:35 A-OUTPUT 2 Rating: 3 mA
:36 DC 0 V A-OUTPUT Reference potential 0 V Analog outp.
A-OUTPUT 1, A-OUTPUT 2
1)
As supplied: Terminals :7, :8, :10, :11, :12 are connected to +24 V (terminal :1).
Terminals :3 and :4 are bridged. The 8230 frequency inverter can therefore be
controlled directly via the control unit.
2)
The function can be re-directed with the PC handling software if required
3)
The function can be inverted if required
4)
The output can be adjusted.
READY
ON
ERROR
SPEED
REACHED
To Next Page
Loading...
