Lenze 8400 - Page 13

Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05 13
2 Features of the technology application
2.8 Pre-assignment of the I/O terminals
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Digital output terminals
X4/DO1 HIGH ≡ "Drive is ready" state
X4/DO2 HIGH ≡ "Actual position is in target position window" state
X4/DO3 HIGH ≡ "Home position is known" state
X107/BD1, BD2 Control of a holding brake by the basic function "holding brake control"
X101/COM, NO Relay contact closed ≡ "An error is pending" state
Analog output terminals
X3/O1U Actual speed value
• Scaling: 10 V ≡ 100 % reference speed (C00011)
X3/O2U Actual torque
• Scaling: 10 V ≡ 100 % maximum torque (C00057)
Terminal Function