9400 Technology applications | Synchronism with mark synchronisation
Parameter setting & configuration
"Synchronism" mode"
32 L EDS94TA10040xxxx EN 1.1 - 10/2008
4.5 "Synchronism" mode"
In the "Synchronism" (C03006 = "0") operating mode the drive follows the master value of
the electrical shaft if the clutch is engaged.
[4-4] "Synchronism" mode (schematic diagram)
Functions in the "Synchronism" operating mode
Master value processing
Mark synchronisation (master value)
Virtual clutch
Master value adjustment
Setpoint processing
Mark synchronisation (setpoint)
O Tip!
A description of the different functions for processing the master value can be
found in the following subchapters.
M
v
Slave
Real master/
Virtual master
C03006 = 0
v
t
Dj
302 4
Dj Dj
15
TP TP
To Next Page
Loading...
