Lenze 9400

9400 Technology applications | Synchronism with mark synchronisation
Parameter setting & configuration
Parameterisable function blocks
72 L EDS94TA10040xxxx EN 1.1 - 10/2008
4.14.22 ShaftStartPosition
4.14.23 ToolControl
C03983 DIS:bPosTeach
• Display of input signal bPosTeach.
0FALSE
1TRUE
C03984 DIS:bBusy
• Display of output signal bBusy.
0 Profile parameters are available.
1 Conversion active, no access to
profile parameters at the moment.
C03985 -2147483647 2147483647 Status
• Display of the bit-coded output
signal dnState.
Parameter Possible settings Information
Is an instance of Function
L_SdSetPosition Conversion of the master shaft starting position selected in the real units of the
machine via C03034 into a position in [increments].
Parameter Possible settings Information
C03034 -214000.0000 unit 214000.0000 Position value
• Initialisation: 0.0000 unit
C03035 String of digits Position unit
•Read only
C03036 -2147483647 2147483647 Status
•Read only
Is an instance of Function
L_LdToolControl Setpoint processing
(C 38)
Parameter Possible settings Information
C03825 -2147483647 2147483647 Status
• Display of the bit-coded output
signal dnState.
C03826/1 String of digits Position unit
•Read only
C03826/2 String of digits Speed unit
•Read only
C03827 -214748.3647 unit/t 214748.3647 Reference speed
•Read only
• Reference value for selecting
speeds.
C03830 -2147483647 unit/t 2147483647 Correction speed at the input
•Read only
• Is generated from the speed
signal dnTpMakeUpLeeway_s.