Safety engineering
Device modules
Slot
1
13
EDS94AYAE EN 6.0
Codes
Parameter: Name: Data type: Index:
C00214 Required safety module
UNSIGNED_8 24361
d
= 5F29
h
Setting of the expected safety module
l If a safety module deviating from this setting is detected, an error (fault) is caused. The error can only be
removed by mains switching.
Selection list
(Lenze setting bold) Information
1 SM0
2 SM100
4 SM300
5 SM301
þ Read access þ Write access o Controller inhibit o PLC-STOP o No transfer o COM o MOT
Note!
In case you exchange the module, the address switch must be set identically
to the module to be replaced. Only then the corresponding safe parameter set
can be transferred to the module.
To Next Page
Loading...
