Lenze E84DGFCG Series - I;O configuration in the Engineer

Lenze · Decentralised frequency inverter 8400 motec (EtherNet/IP™ option) · EDS84DMOTEIP EN 2.0 - 10/2013 52
I/O data transfer (implicit messages)
I/O configuration in the »Engineer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.5 I/O configuration in the »Engineer«
8.5.1 Lenze technology application / configuring user-definable parameter sets
 How to configure the Lenze technology applications / user-definable parameter sets in the
»Engineer«:
1. Select the application (C00005 = 1000) in the Application parameters tab.
In the example, the "speed actuating drive" application is configured.
2. Make the default setting of the I/O configuration.
Select "MCI" control mode (C00007 = 40).