Lenze E84DGFCG Series - Page 83

Error messages
Possible causes and remedies
83
Lenze · Decentralised frequency inverter 8400 motec (EtherNet/IP™ option) · EDS84DMOTEIP EN 2.0 - 10/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
EtherNet/IP: Restart by watchdog reset [0x01bc6010]
EtherNet/IP: Internal Error [0x01bc6011]
EtherNet/IP: Internal error [0x01bc6100]
EtherNet/IP: Internal error [0x01bc6101]
EtherNet/IP: Invalid parameter set [0x01bc641f]
EtherNet/IP: Lenze setting Loaded [0x01bc6420]
Response (Lenze setting printed in bold) Setting: C01501/2 ( Adjustable response)
 No reaction  System fault  Fault  Trouble  TroubleQuickStop  WarningLocked  Warning  Information
Cause Remedy
Device is defective. Send the device and a description of the fault to Lenze.
Response (Lenze setting printed in bold) Setting: C01501/2 ( Adjustable response)
 No reaction  System fault  Fault  Trouble  Quick stop by trouble  WarningLocked  Warning  Information
Cause Remedy
Device is defective. Send the device and a description of the fault to Lenze.
Response (Lenze setting printed in bold) Setting: C01501/2 ( Adjustable response)
 No reaction  System fault  Fault  Trouble  TroubleQuickStop  WarningLocked  Warning  Information
Cause Remedy
Device is defective. Send the device and a description of the fault to Lenze.
Response (Lenze setting printed in bold) Setting: C01501/2 ( Adjustable response)
 No reaction  System fault  Fault  Trouble  TroubleQuickStop  WarningLocked  Warning  Information
Cause Remedy
Device is defective. Send the device and a description of the fault to Lenze.
Response (Lenze setting printed in bold) Setting: C01501/2 ( Adjustable response)
 No reaction  System fault  Fault  Trouble  TroubleQuickStop  WarningLocked  Warning  Information
Cause Remedy
No active parameter set could be loaded. • Download application again (including module).
• Send the device and a description of the fault to
Lenze.
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Access to parameter set was not possible. • Download application again (including module).
• Send the device and a description of the fault to
Lenze.