Lenze ECSEM Series - Page 294

Appendix
Code table
12

294
EDBCSXM064 EN 11.0
IMPORTANTPossible settingsCode
SelectionLenze/
{Appl.}
DesignationNo.
C0196 BRK T rel 0.0
Opening time of the motor
holding brake
 105
0.0 {0.1 s} 60.0 During the time set the drive can
generate the torque set under
C0244 against the holding brake.
After the set time has elapsed,
the status "mechanical brake
opened" is reached.
C0199 BuildNumber Software identification
Only display
C0200 S/W Id Software identification
Only display
C0201 S/W date Software release date
Read only
C0202 Service code
Only display
1 Product code 1
... ...
4 Product code 4
C0203 Komm.−No. x / xxxx / xxxxx Commission number
Only display
C0204 Serial−No. Serial number
Read only
C0205 PLC Target ID Identification key
Only display
C0206 Product. date Production date
Only display
C0207 DL info 1 Download info 1
Only display
C0208 DL info 2 Download info 2
Only display
C0209 DL info 3 Download info 3
Only display
C0244 BRK M set 0.0
Holding torque of the drive
against the motor holding brake,
with reference to M
max
(C0057).
 105
0.00 {0.01 %} 199.99 During the time set in C0196 the
drive generates the set torque
against the holding brake.
C0250 FCODE 1 Bit 0
Freely selectable digital signal
(1 bit)
0 1
C0254 Vp angle CTRL 0.4000
Phase controller gain (V
p
)
0.0000 { 0.0001} 3.9999
C0300
Service Codes Only the Lenze service is allowed
to make changes!
...
C0302
C0304
Service Codes Only the Lenze service is allowed
to make changes!
...
C0310