Lenze i510 protec Series

Commissioning
Operang Instrucons i510 protec 19
7.2.4 Extended terminal control
The following illustraon shows a more extensive wiring of the control
terminals (X3, X9 and X216) linked with the respecve parameters.
GND
AI1
AI2
AO1
10V
24V
DI1
DI2
DI3
DI4
DI5
GND
DO1
NO
COM
NC
U/I
*P400.02
Preset 01 (*P450.01)
*P400.04
*P400.13
bit 1 bit 0
0
0
1
1
1
1
Preset 02 (*P450.02)
Preset 03 (*P450.03)
*P400.18
*P400.19
*P420.02
*P420.01
24E
*P201.01
(configured AI1 as
standard setpoint)
Default seng
Start
Reset error
Mark direcon of rotaon
Acvate preset (bit 0)
Acvate preset (bit 1)
DO1 acvated at
Release brake
Relay acvated at
Ready for operaon
Analog input 1
24 V DC, 100 mA supply, reference for digital inputs
Digital input 1
Digital input 2
Digital input 3
Digital input 4
Digital input 5
Digital output 1
GND for analog and digital signals
Relay NO contact
Relay common contact
Relay NC contact
Preset frequency values
*P430.01 (0 ... 10 V DC signal)
Analog input 2
*
Analog output 1
10 V DC supply for potenometer
P430.02 ... *P430.03
range [Hz]:
config.:
Oponal external 24-V-supply
GND for analog and digital signals
7.3 Keypad control
Acvatetemporarykeypadcontrol
1. Press the
key to acvate the keypad control.
2. Press the
key to conrm the keypad control.
Deacvatetemporarykeypadcontrol
1. Press the
key to deacvate the keypad control.
2. Press the
key to conrm the keypad control.
Acvatepermanentkeypadcontrol
If the keypad does not have a
key, the motor control is acvated via
the following parameters:
► Set parameter P200.00 to 1.
► Set parameter P201.01 to 1.
► Set parameter P400.01 to 1.
► Set parameter P400.02 to 1.
Use the
key to start the motor.
Start/control/stop motor with keypad
1. Press the
key to start the motor.
• The keypad shows the motor speed.
2. Use the
key or the key to change the frequency setpoint.
3. Press the
key to stop the motor.
Changerotangdirecon
1. Press the
key.
2. Press the
key to conrm the reversal of rotang direcon.
7.4 Commissioning with the EASY Starter
Commissioning and diagnoscs can be carried out with the
EASY Starter engineering tool. hps://www.Lenze.com