Lenze i510 protec Series

Safety instrucons
Operang Instrucons i510 protec 5
1.5 Idencaonoftheproducts
I 5 1 A P xxx x 1 x x x x x xxx
Product type Inverter I
Product family i500 5
Product i510 1
Product generaon Generaon 1 A
Mounng type Wall mounng P
Rated power
kW
(examples)
0.37 kW 137
0.55 kW 155
2.2 kW 222
Mains voltage and
connecon type
(examples)
1/N/PE AC 120 V A
1/N/PE AC 230/240 V B
3/PE AC 230/240 V C
1/N/PE AC 230/240 V
3/PE AC 230/240 V
D
3/PE AC 400 V
3/PE AC 480 V
F
Product extension None 0
Integrated
funconal safety
Without safety funcon 0
Degree of
protecon
IP20, uncoated 3
Interference
suppression
Without 0
Integrated RFI lter 1
Operaon area Default parameter:
EU region (50-Hz networks)
0
Default parameter:
US region (60-Hz networks)
1
Design types
(examples)
Standard I/O ... 0
Keypad-module with Standard I/O ... K
WLAN module with Standard I/O ... W
USB module with Standard I/O ... U
... without network 005
... with CANopen 02S
... with Modbus RTU 03S
For the design type with a keypad, the rst 0 is replaced by the leer K;
for the WLAN type, it is replaced by the leer W.
2 Safetyinstrucons
2.1 Basic safety measures
Disregarding the following basic safety measures may lead to severe
personal injury and damage to property!
Observe all specicaons of the corresponding documentaon supplied.
This is the precondion for safe and trouble-free operaon and for
obtaining the product features as specied.
• The product:
• must only be used as directed.
• must never be commissioned if they display signs of damage.
• must never be technically modied.
• must never be commissioned if they are not fully mounted.
• must never be operated without required covers.
• must only be disconnected from the installaon in de-energized
condion.
• Connect/disconnect all pluggable terminals only in de-energized
condion.
Deviceprotecon
• Carry out insulaon resistance tests between 24-V control potenal
terminals and PE. The maximum test voltage must not exceed
DC 110 V.
Process engineering
The procedural notes and circuit details described are only proposals. It
is up to the user to check whether they can be adapted to the parcular
applicaons. Lenze does not take any responsibility for the suitability of
the procedures and circuit proposals described.