Lenze i510 protec Series

Further documents
Operang Instrucons i510 protec28
8.4 LED status
LED “RDY” (blue) LED “ERR” (red) Status/meaning
o o No supply voltage
Mains voltage is switched on, inverter is
inialized
ashes
o Inverter is disabled, ready for operaon
ashes fast
Safe torque o (STO) acve, warning acve
ashes
o Inverter inhibited
ashes fast
Inverter disabled, warning acve
Inverter disabled, error acve
every 1.5 s on
Inverter disabled, no DC bus voltage
o Inverter enabled
o The motor rotates according to the specied
setpoint or quick stop acve
ashes fast
Inverter enabled, warning acve. The motor
rotates according to the specied setpoint or
quick stop acve
ashes
Inverter enabled, quick stop as response to fault
acve
9 Further documents
For certain tasks, informaon is available in further documents.
Document Contents/topics
Project planning document Fundamental informaon on project planning and ordering the product
Commissioning document Fundamental informaon for the installaon and commissioning of the
product
Mounng instrucons Fundamental informaon on mounng the product
The documents can be found online: hp://www.Lenze.com
10 Disposal
If pollutants are disposed o improperly, they may cause a lasng
damage to human health and the environment. Thus, electrical and
electronic equipment must be collected separately from unsorted
municipal waste so that it may be recycled or disposed of properly.
If available, put the components to the company internal disposal from
where it is passed on to specialized waste management companies.
It is also possible to return the components to the manufacturer. For this
purpose, please contact the customer service of the manufacturer.
More detailed informaon on disposal can be obtained from the
corresponding specialist rms and the competent authories.
The packaging of the component must be disposed of separately. Paper,
cardboard and plascs must be recycled.
11 Glossary
Abbreviaon Meaning
AIE Error acknowledgement (“Acknowledge In Error”)
OFF state Signal status of the safety sensor when it triggers or responds
QSP Quick stop