can use the "View Disk Log" button to view the results.
Terminated - The last Scandisk operation was cancelled by the
Administrator before it was completed.
Schedule
Use these fields to set up a schedule to run Scandisk regularly, if desired.
The available options are:
Never - Scandisk will not be scheduled to run.
Every Day - select this to have scandisk run each day, at the speci-
fied time.
Every Monday, Every Tuesday, ... - Select this to have the scandisk
run once per week, on the specified day.
Use the time fields (hour, minute, am/pm) to specify when the scandisk
operation should be performed.
This can have any of the following values:
Not Installed - No disk is available.
Not Checked - No S.M.A.R.T. check has been performed on this
drive since system boots up.
OK - No errors were found in the last test.
Going to fail - The S.M.A.R.T. check found errors on the drive and
the disk is going to fail.
Schedule
Use these fields to set up a schedule to run S.M.A.R.T. check regularly, if
desired. The available options are:
Never - S.M.A.R.T. check will not be scheduled to run.
Every Day - Select this to have S.M.A.R.T. check to run each day,
at the specified time.
Every Monday, Every Tuesday, ... - Select this to have the scandisk
run once per week, on the specified day.
Use the time fields (hour, minute, am/pm) to specify when the S.M.A.R.T.
check should be performed.
Use the "Set Hard Disk to standby mode…" setting to determine if and
when the hard disk drives should be switched to "Standby" mode.
Use the "Turn off the fan…" setting to determine if and when the fan should
be turned off.
Click this button to enter the screen of changing Disk Mode.
Use this button to format the disk. This will partition and quick-format the
new disk.
WARNING! This will destroy any data on the disk. Once started, this
process can NOT be halted or reversed.
Start - Click the button to start the Scandisk. The Scandisk could take
To Next Page
Loading...
