This indicates the current working mode of Internal Disks. It can be one
following modes:
Separate Disks
Disk 1 and Disk 2 work separately (Recommended).
JBOD/LVM
Disk 1 and Disk 2 are bound into one logical volume. Total capacity
is equal to the capacity of the existing drive(s). To work in this con-
figuration, at least one drive must exist. If this configuration is
selected with only one drive installed, the second drive will be con-
figured to extend the capacity of the logical volume when it is
installed.
Mirroring (Raid 1)
Disk 1 is mirrored into Disk 2. Total capacity is equal to the capacity
of smaller drive. To select this mode, both drives must exist.
Striping (Raid 0)
Disk 1 and Disk 2 are striped into one logical volume. Total capacity
is equal to two times the smaller capacity of the two drives. To se-
lect this mode, both drives must exist.
This includes status of Internal Disk and USB Disks.
Internal Disk:
No Installed - No disk is inserted, or connection or disk has failed.
Not Formatted - Disk has been detected, but it is not ready for use.
Use the "Format" button to prepare the disk for use.
Formatting - This message will only be displayed after you have
clicked the "Format" button. (See below for details of this button.)
Formatted - Disk is ready for use.
USB Disks:
No Installed - No disk is inserted into this USB port.
Not Formatted - This USB disk hasn't been formatted into FAT or
NTFS file system. You can click "Format" button to format it.
Formatted - Disk is ready for use.
This can have any of the following values:
N/A - No disk is available.
No Scanned - No Scandisk has been performed recently on this
drive.
Scanning - Scandisk operation is in progress. The disk cannot be
used while a Scandisk is in progress. If required, use the "Stop"
button to terminate the Scandisk operation and gain access to data
on the disk. (To see the results of the Scandisk operation, use the
"View Disk Log" button.)
Completed - The last Scandisk operation has been completed. You
To Next Page
Loading...
