25
3. Rediscovery PL
This feature allows you to
change the power level used
for network rediscovery (refer
to Network Rediscovery
pg. 19).
4. Device Properties
(refer to Device Properties pg. 23).
5. Tests
This feature will allow you to test certain aspects
of your Z-Wave
®
network.
Test Routes - Tests the connection between
Dimmers/Switches and the Controller they are
associated to.
Test Links - Tests the direct radio frequency link
between any two devices.
Factory Test - WARNING: FOR FACTORY
USE ONLY! DO NOT USE.
6. Reset
Resets your VRCPG back to
factory default and erases any
programmed information from
the remote. NOTE: Resetting
the VRCPG to factory default
does not reset your devices. If
you want to factory reset your
devices refer to the individual
device instruction sheet for
that device.
To Next Page
Loading...