Table 6: Specifications for minimum bending radius of motor and adaptor cables
Note: If not mentioned explicitly all the cables are not suitable for constant dynamic bending and movement!
Figure 11: Basic dimensions (in mm and [inch]) of air cooling module ACM-600.2
Note 1: Non-tolerated dimensions are for reference only. Note 2: Not to be used for ATEX / IECEx applications)
Figure 12: Basic dimensions (in mm) of controller LPC-600.2
Note 1: Non-tolerated dimensions are for reference only. Note 2: Same basic dimensions for LPC-600.1)
To Next Page
Loading...
Need help?
General
