Lexicon 300 - Page 66

The Algorithms axl their Parameters
u
Rich Plate Tweaks Page
RAND sets the rate of the randomization process. Plates should generally use
low amounts of randomization.
SHAPand SPRD worktogethertocontroi theoverallambienceof the reverbera-
tion created by the 300. SHAP determines the contour of the reverberation
envelope. With SHAP all the way down, reverberation builds explosively, and
decays quickly.
As SHAP is advanced, reverberation builds up more slowly and sustains forthe
time set by SPRD. With SHAP in the middle, the buildup and sustain of the
reverberation envelope emulates a large concert hall (assumrng that SPRD is at
least halfway up, and that SIZE is suitably large-30 meters or larger.)
SPRD works togetherwith SHAP to control the duration of the initial ambience
created by the 300. Low SPRD settings resuit in a rapid onset of reverberation
at the beginning of the envelope, with little or no sustain. Higher settings spread
out both the buildup and sustain.
DIFF controls the degree to which initial echo density increases over time. High
settings of DIFF result in high initial buildup of echo density; low settings cause
low initial buildup. Echo density is also affected by SIZE; smaller spaces will
sound denser. To enhance percussion, use high settings of DIFF. Forclearer,
more natural vocals, mixes, and music, use low or moderate settings.
When LINK is set, the reverb time and spread values scale linearly as the SIZE
control is varied. For some special effects, RTIM and SPRD can be unlinked.
SIZE allows you to vary the apparent size of the space over a wide range. SIZE
isthemost dramaticcontroi,and must beselectedto matchthe musicorprogram
material. It should be the first control that you adjust io tailorthe desired space.
SIZE also affects the reverb time, in a similar way to the standard reverb
programs.
Rich Plate Delay and Feedback Pre-Echoes Page
Thesepagesprovidecontroloverthree stereodelaypairs. All three aresummed
with the output of the reverberator. Many, many different echo combinations are
possible.
DLYl and DLY2 (Oms2OOOms) are recirculating delay lines to the left and right
channel inputs. The path of either is picked off after the diffuser with the amount
of recirculation defined by the adjustment of FBKI (for DLYi) and FBK2 (for
DLY2). DLYI and DLY2 are the only delays which effectively feed back
(recirculate) into the reverberator.
RAND (Randomization)
SHAP (Shape)
SPRD (Spread)
DIFF (Diffusion)
LINK
SIZE
DLYl . DLY2
4-13