Lexicon MX300 - Guitar - Effects Loop Setup; Instrument - in Line Setup

Guitar - Effects Loop Setup
Effects
Send
Effects
Return
This setup is optimized for use within a guitar amplifier effects loop system. A single
input source is fed into the MX300 and output as a mono signal. The Input Source
must be set to Anlg Mono L in the System menu (described on page 30). This setup
is ideal for programs using Cascade, Parallel, and Stereo routings (see page 16 for more
information about routings).
Instrument - In Line Setup
Stereo
Line Input
This setup allows a line level instrument such as an electronic keyboard to be connected
directly to the MX300. Connect the outputs of the line level instrument to the MX300
inputs and connect the MX300 outputs to the input channels of a mixer, or the inputs
of a powered speaker system. The Input Source must be set to Anlg Stereo in
Connecting the MX300
10