Using the MX300
16
EFFECT MIX/ROUTING
Each of the MX300 programs offers programmable effect routing and a wet/dry mix
parameter for each effect. These different routings and mix controls give you many
options for your effect signal path and precise control over balance between the two
effects.
Using the MX300
16
eFFect mIX/routIng
Each of the MX300 programs offers programmable effect routing and a wet/dry mix
parameter for each effect. These different routings and mix controls give you many
options for your effect signal path and precise control over balance between the two
effects.
Routing Options:
1 - Dual Mono
This routing option sends the Left and Right input signals through Effect 1 and
Effect 2 respectively. Each signal is then routed to its respective output, completely
independent from the other.
2 - Cascade
Left and Right input signals are sent first through Effect 1, then through Effect 2,
then routed as a stereo signal to their respective outputs.
3 - Parallel (Dual Stereo)
Left and Right input signals are sent through both effects independently. The out-
put signals of both Effects are then mixed together, and routed to both the outputs
as a single stereo signal.
4 - Mono Split
Left input signal is sent through Effect 1, while the Right input signal is sent
through Effect 2. The output signals of both Effects are then mixed together, and
routed to both the outputs as a single stereo signal.
5 - Stereo
Routing 5 provides a single high-quality stereo effect that utilizes all the MX300’s
DSP horsepower. With extra editable parameters and an increased complexity
of the reverb algorithms, use this routing when all you need is a powerful stereo
effect for your application.
Routing Options:
1 - Dual Mono
This routing option sends the Left and Right input signals through Effect 1 and Effect
2 respectively. Each signal is then routed to its respective output, completely indepen-
dent from the other.
2 - Cascade
Left and Right input signals are sent first through Effect 1, then through Effect 2, then
routed as a stereo signal to their respective outputs.
3 - Parallel (Dual Stereo)
Left and Right input signals are sent through both effects independently. The output
signals of both Effects are then mixed together, and routed to both the outputs as a
single stereo signal.
4 - Mono Split
Left input signal is sent through Effect 1, while the Right input signal is sent through
Effect 2. The output signals of both Effects are then mixed together, and routed to both
the outputs as a single stereo signal.
5 - Stereo
Routing 5 provides a single high-quality stereo effect that utilizes all the MX300’s DSP
horsepower. With extra editable parameters and an increased complexity of the reverb
algorithms, use this routing when all you need is a powerful stereo effect for your
application.
To Next Page
Loading...
