Lexicon MX300 - Analog Output

sources. The MX300 offers three different input sources to select from:
Anlg Mono L (Left), Anlg Stereo, and Digital. Input Source refers to
whether you will be using the analog Input pair or the S/PDIF digital input.
When only a single analog input is to be used, connect to the analog Input
Left input only and select Anlg Mono L as the Input Source. All inputs
(analog and digital) can remain connected simultaneously in the event
you find yourself switching between using both. Use Knob A to select the
appropriate Input Source you will be using
Clock Source
This option allows manual selection of either the internal or external
clock source for the MX300. When set to 44.1kHz, the MX300 utilizes an
internal clock with a 44.1kHz sample rate. When set to 48kHz, the MX300
utilizes an internal clock with a 48kHz sample rate. When set to Digital,
the unit utilizes the S/PDIF input clock source, even if an analog audio
source is used. Refer to The MX300 and Digital I/O section on page 12
for more information on using digital audio sources. Use Knob B to select
the appropriate Clock Source you will be using.
Digital Out
The MX300 can send unprocessed digital audio out its S/PDIF Digital
Output while monitoring processed audio through the analog outputs.
This is useful when you want to record a dry performance digitally, but also
hear effects processing while you are recording. Note: This feature is only
available for signals brought into the MX300 via the analog inputs. It has
no effect on signals being received at the S/PDIF In. Digital in/out signals
are processed normally regardless of whether the Digital Out settings are
set to Dry. To send unprocessed audio out the MX300 digital outputs, use
Knob C to set the Digital Out option to Dry.
System Menu
B
C
A
ANALOG OUT
ANALOG OUT LEVEL
ANLG STEREO
+4dBU
TEMPO DISPLAY BPM
Analog Output
The MX300 analog outputs can be configured to run in stereo or in mono.
When only a single output cable is to be used, connect to the Output Left
output only and set the Analog Output Mode to Anlg Mono L. Output
Mode only affects the analog outputs. Use Knob A to select between Anlg
Mono L and Anlg Stereo.
31
MX300 System Menus
MX300