QUICK START
Ideally, you should read this entire manual before using the MX300. But, if you just
can’t wait to get started, this section explains how to set up a simple parallel connec-
tion (using the MX300 with a mixer) and select a program.
STANDARD PARALLEL CONNECTION
1. Connect the mixer’s Post Fader Aux Send outputs to the MX300’s Left and Right
inputs.
2. Connect the MX300 Left and Right outputs to a stereo Aux Return input on the
mixer (or a stereo line input, or two adjacent line inputs if you like).
Aux
Send 1
Aux
Return 1
Aux
Send 2
Aux
Return 2
POWERING THE UNIT
1. Plug the included power cord into an A/C outlet.
2. Connect the power cord to the Power Jack connection on the MX300’s back
panel and turn on the MX300's power.
Power
SET AUDIO LEVELS
1. Set the gain on the mixer’s input channel appropriate to the source (vocal mic,
guitar, keyboard, etc.).
2. Set the Aux Master level (if provided on your console) to the 12 o’clock position.
3. Set the Input level on the MX300 to the 12 o’clock position.
4. Provide a signal source signal on the selected mixer channel.
5. Turn up the Aux Send levels on the channel corresponding to the Post-fader send
(Aux 1 and Aux 2 in this example) that the MX300 is connected to until the red
Input Gain LEDs light only occasionally. If the red Input Gain LEDs stay lit,
too much signal is being sent to the MX300; reduce the Aux Master or Aux Send on
the mixer.
2
Quick Start
To Next Page
Loading...
