Using the MX300
USING THE MX300
SELECTING AND LOADING PROGRAMS
1. Choose a program by rotating the Program knob. The selected program number
flashes in the Program Display until loaded. The name of the program also
appears in the MX300’s Main Display. The Factory or User light next to
the Program Display lights to indicate whether a Factory or User program is
selected.
2. Press the Program knob to load the program. If you would like the programs
to be loaded automatically as they are selected with the Program knob, you can
enable the Auto Load in the MX300’s System menu.
STORING/COPYING PROGRAMS
1. Press the Store button once. You will now be on the program naming
screen.
2. Turn the Page/Select knob to move the cursor to the character you want
to change. Turn Edit Knob A to change the character. Turn Edit Knob
B to change the letter case. Press the Page/Select knob to clear a charac-
ter from the name.
3. When naming is complete, press the Store button again. Turn the Page/
Select or Program/Load knob to select the new user program memory
location to store to.
4. Press the Store button again to complete the store procedure.
EDITING A PROGRAM
Once a program has been loaded, you may find you want to make adjustments to it
for your particular application or use. Editing of programs is done using the Page/
Select and three Edit knobs (A, B, and C) to the right of the Main Display. Each
effect can be edited independently by selecting it with the Page/Select knob. As the
effect is selected, its name is highlighted in the Main Display and three parameters
become visible for the effect at the bottom of the Main Display. The Edit knobs can
then modify these three top level parameters.
13
MX300
To Next Page
Loading...
