Using the MX300
15
1. While on the Program you would like to edit, press the Page/Select knob.
This will enter the Program Edit menus.
2. Turn the Page/Select knob until the Change Effect menu is highlighted.
Change Effect 2 is selected in our example.
3. Press the Page/Select knob to enter the Change Effect 2 menu.
4. Once in the Change Effect menu, turn the Page/Select knob to move
through the library of effects until you find the one you want to use.
5. Press the Page/Select knob to load the newly selected effect into the effect
location. You will be able to hear the new effect in place in the effect rout-
ing at this time. If you choose not to select a new effect, press the Exit but-
ton to abort changing effects.
TAPE DLY
1
DRM PLATE
2
2
Program Name
Change Effect
1
2
EDIT EFFECT
EDIT MIX/ROUTING
CHANGE EFFECT
2
DRUM PLATE
1
2
ARENA
GATED REVERB
(SELECT) - LOAD
(EXIT) - ABORT
2
When finished, store the changes to the program if you would like them to be recalled.
CHANGING KNOB ASSIGNMENTS
The three parameters that appear for editing from the Program Screen when a pro-
gram using routing 5 - Stereo (single effect) is loaded are user selectable. From the
factory, these parameters were selected for these programs by their importance to the
effect. If you would like to access other parameters for this effect from the Program
Screen, you can select these in the Knob Assignments menu. These assignments are
individual to each program so you can customize specific parameters for each effect
depending on the program.
1. While on the Program Screen, press the Page/Select knob. This will enter the
Program Edit menus.
2. Turn the Page/Select knob until the Knobs Assign menu is highlighted.
3. Press the Page/Select knob to enter the Knobs Assign menu.
4. Turn either the A, B, or C knobs to select which parameter you want available for
editing from the Program Screen.
When finished, store the changes to the program if you would like them to be recalled.
MX300
To Next Page
Loading...
