Use To
Manually Set Date and Time
[input date/time]
Enter the date and time.
Notes:
• Manually setting the date and time sets Enable NTP to No.
• The wizard lets you set the date and time in YYYY‑MM‑DD‑HH:MM
format.
Time Zone
[list of time zones]
Select the time zone.
Note: GMT is the factory default settings.
Automatically observe DST
On
O
Set the printer to use the applicable daylight saving time (DST) start and end
times associated with the printer Time Zone setting.
Note: On is the factory default setting.
Enable NTP
On
O
Enable Network Time Protocol, which synchronizes the clocks of devices on a
network.
Notes:
• On is the factory default setting.
• This setting is turned o if you manually set the date and time.
Understanding printer menus 144
To Next Page
Loading...
