Quality menu
Use To
Print Mode
Color
Black Only
Specify whether to print images in color.
Note: Color is the factory default setting.
Color Correction
Auto
O
Manual
Adjust the color output on the printed page.
Note: Auto is the factory default setting.
Print Resolution
1200 dpi
4800 CQ
Specify the output resolution in dots per inch (dpi) or in color quality (CQ).
Note: 4800 CQ is the factory default setting.
Toner Darkness
1–5
Lighten or darken the output.
Note: 4 is the factory default setting.
Enhance Fine Lines
On
O
Enable a print mode preferable for files such as architectural drawings, maps,
electrical circuit diagrams, and flow charts.
Note: O is the factory default setting.
Color Saver
On
O
Reduce the amount of toner used for graphics and images.
Notes:
• O is the factory default setting.
• On overrides the Toner Darkness setting.
RGB Brightness
‑6 to 6
Adjust the brightness of the output.
Note: 0 is the factory default setting.
RGB Contrast
0–5
Adjust the contrast of the output.
Note: 0 is the factory default setting.
RGB Saturation
0–5
Adjust saturation in color outputs.
Note: 0 is the factory default setting.
Color Balance
Cyan
‑5 to 5
Magenta
‑5 to 5
Ye l l o w
‑5 to 5
Black
‑5 to 5
Reset Defaults
Enable an equal balance of colors in the output.
Note: 0 is the factory default setting.
Understanding printer menus 184
To Next Page
Loading...
