47
If the jam occurs in the fuser:
1 Open the printer cover.
2 Remove the print cartridge (it may be warm).
Note: Exposing the photoconductor to light may damage the print cartridge. After you
remove the print cartridge from the printer, cover it or store it in a clean, dark place.
3 Gently pull out the media.
CAUTION: Avoid touching the fuser, it may be hot!
4 If the media is jammed tightly behind the roller, or if you just can’t get a grip on it, close the
cover, open the front output door, and pull out the paper.
5 Make sure there is no more media in the printer.
6 Reinstall the print cartridge.
7 Close the printer cover to resume printing.
A jam may occur if the output bin is too full and the media is unable to exit the printer:
1 Empty the media from the output bin.
2 Clear the jam.
Fuser
Roller
To Next Page
Loading...
