60
What this light sequence means:
The printer is out of media or envelopes, or the media did not
feed properly.
What you can do:
• Load media into tray 1 or the optional tray 2 and
push the operator panel button to resume printing.
• Check that the media is loaded correctly in tray 1 or
the optional tray 2.
• Cancel the job. Push the operator panel button until
all the lights come on to reset the printer.
What this light sequence means:
The printer is out of media or envelopes, or the media did not
feed properly. In addition, the toner in the print cartridge is
getting low.
What you can do:
• Load media into tray 1 or the optional tray 2 and
push the operator panel button to resume printing.
• Check that the media is loaded correctly in tray 1 or
the optional tray 2.
• Remove the print cartridge and shake it to extend
the life of the cartridge.
• Replace the print cartridge.
Note: The Toner Low light does not come on if
the standard 1,500-page print cartridge
is installed in the E320.
To Next Page
Loading...
