– Unsupported imaging unit service check
– Supplies mismatch service check
February 18, 2016
• Added the topic “Enabling the security reset jumper” in ”Appendix A: Printer specifications” chapter.
February 10, 2016
• Updated the art and table for the topic “Covers” in the “Parts catalog” chapter.
January 20, 2016
• Revised step 2 of the topic “Entering invalid engine mode” in the ”Configuration menu” group in the “Service
menus” chapter.
December 1, 2015
• Updated the topic “Toner density sensor removal” in the ”Bottom removals” group in the “Repair information”
chapter to add installation notes.
October 29, 2015
• Updated the topic “Option trays” in the “Parts catalog” chapter to revise its art.
• Updated the topic “ACM assembly removal” in the “Repair information” chapter to revise its art.
August 19, 2015
• Updated “Laser scanning unit (LSU) removal” on page 278 to add a note regarding the correct sequence
of tightening the screws when reinstalling the polygon LSU.
August 7, 2015
• Updated “Electronics 1” on page 295 to add PN 41X0913 for the video cable that is applicable only for
models with galvo LSU.
June 18, 2015
• Updated “Frame” on page 300 to change the part numbers for the pick tires (from 41X0547 to 41X0918)
and ACM assembly (40X8260 to 41X0919).
May 13, 2015
• Updated “200 paper jam messages” on page 87 to add error codes specific to polygon laser scanning
unit (LSU).
• Updated “111 error messages” on page 122 to add error messages
specific
to polygon LSU. Added notes
to identify the type of LSU (polygon or galvo) and controller board the printer supports.
• Updated “Laser scanning unit (LSU) service check” on page 125 to include other ways to resolve LSU-
related issues. Added notes to identify the type of LSU (polygon or galvo) and controller board the printer
supports.
• Updated “Laser scanning unit (LSU) removal” on page 278 to add information on how to identify the type
of LSU (polygon or galvo) and controller board the printer supports.
• Updated “Electronics 1” on page 295 to specify whether the LSU that the printer supports is a polygon or
galvo. Added in the table these two FRUs: Polygon LSU frame (PN 41X0363) and Polygon LSU cable
(41X0759).
4514-330
Change history
25
To Next Page
Loading...
