Lexmark MS317 - Large Jobs Do Not Collate

• Horizontal lines for skew adjustment
• General printer information, including current page count, installed memory, processor speed, serial
number, engine ID, and controller board ID
3 Check the Quick test page for the correct
oset
between the placement of the
first
scan line on the front
and back side of a duplexed sheet.
4 If adjustment is necessary, the top margin in the Registration menu must be adjusted first. The duplex top
margin oset may be adjusted next. A positive oset moves the text down the page and widens the top
margin, while a negative oset moves the text up the page and narrows the top margin.
Top Margin
This setting controls the oset between the placement of the first scan line on the front and back side of a
duplex sheet.
Note: If adjustment is necessary, the top margin in the Registration menu must be adjusted
first.
The duplex
top margin may be adjusted next.
To adjust this setting:
1 From the Diagnostics menu, navigate to:
Duplex Tests > Top Margin
2 Change the margin value.
Changing the value by 1 unit moves the margin by 1/100 in. A positive value moves the text down the page
and widens the top margin. A negative value moves the text up the page and narrows the top margin.
3 Press OK to save the desired margin value.
Left Margin
This setting allows the user to shift the position of the left margin of the back side of a duplexed page to the
left or right. The default margin is 1/4 in.
To adjust this setting:
1 From the Diagnostics menu, navigate to:
Duplex Tests > Left Margin
2 Change the margin value.
Each increment corresponds to 4 pels at 600 dpi (0.00666 in. or 0.1693 mm). A more positive oset moves
the margin to the right, and a more negative oset moves the margin to the left.
3 Press OK to save the desired margin value.
Sensor Test
Use this test to determine if the duplex sensor and switches are working properly.
4514-330
Service menus
167