A
Toner density sensor removal
1 Remove the left cover. See “Left cover removal” on page 207.
2 Remove the main drive gearbox. See “Main drive gearbox removal” on page 208.
3 Remove the rear door and cover. See “Rear door and cover removal” on page 270.
4 Remove the power supply. See “Power supply removal” on page 252.
5 Remove the power supply shield. See “Power supply shield removal” on page 253.
6 Remove the duplex. See “Duplex removal” on page 254.
7 Disconnect the spring (A) from the printer.
4514-330
Parts removal
257
To Next Page
Loading...
