3 Turn on the printer.
4 Release the buttons when a line of dots appears.
Factory Defaults
This restores the printer's settings to the network settings (on network models only) or to the base printer
settings.
Restore Base
Warning—Potential Damage: This operation cannot be undone.
This restores all non-critical base device NVRAM settings to their factory default settings.
Restore STD NET
Warning—Potential Damage: This operation cannot be undone.
This restores all network NVRAM settings. The printer immediately performs a POR and restores the appropriate
settings to their factory default values. This option is available only on models with an integrated network
adapter.
Reports
Menu Settings Page
This prints the Menu settings page which contains the Configuration menu settings and their current values.
Event Log
Additional diagnostic information is available when the event log is printed. The
first
page of the report shows
the general device information.
The specific events that appear in the report vary depending on the operational history of the printer. Logs may
be printed from the following events:
• Job accounting log failures
• NV reset failures
• NV mirror entries
• 9xx and 1xx (print engine) service error entries
• Programming error entries
• Maintenance count reset entries
• Clear log entries
• Paper jam entries
• Firmware update entries
• JFFS2 partition format entries
• USB setup pkt info entries
• Supply event entries
4514-330
Service menus
176
To Next Page
Loading...
