Sensor (fuser exit) static jam service check
Action Yes No
Step 1
Make sure that the paper is loaded properly. Use the
recommended paper. See
“Avoiding jams” on page 66.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
a Reseat the fuser cables from the controller board.
b Reseat the fuser cable from the LVPS.
c Reseat the fuser cable from the extension cable.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
Check if the fuser cam is functional and free of damage.
Is the fuser cam functional and free of damage?
Go to step 5. Go to step 4.
Step 4
Replace the fuser cam. See
“Fuser actuator removal” on
page 182.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
a Enter the Diagnostics menu, and then navigate to:
Printer diagnostics and adjustments > Sensor tests
b Find the sensor (Fuser exit).
Does the sensor status change while toggling the sensor?
Go to step 7. Go to step 6.
Step 6
Replace the fuser. See
“Fuser removal” on page 234.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Step 7
Check the fuser for problems. See
“Fuser error service check” on
page 110.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
4600-830, -835, -895
Diagnostics and troubleshooting
89
To Next Page
Loading...
Need help?
General
