Output options
119
Features
The following table outlines the finisher’s functions.
Note:
You cannot use both the staple and offset functions on the same print job.
You can, however, use the hole punch function with any other finisher
functions.
Finishing capabilities for the 2500-sheet finisher
Finisher feature Capability
Hole punch 3 or 4 hole (static configuration)¹
Hole punch bins Both bins
Staple low sensing The printer displays a
Staples Low
message when
approximately 40 staples are left.
Staple presence sensing Yes
Staple capacity 5,000 staples
Maximum staple packet size 50 sheets (20 lb plain letter size paper)
Staple packet size sensing No
Staple positions One (upper left corner for letter/A4 size paper)²
Staple bins Bin 2 only
Paper offset 40 mm (1.57 in.)
Paper offset bins Bin 2 only
¹ You cannot configure the hole punch position for your job when you send it to print. Unique
equipment must be installed for the 3 or 4 hole configuration.
² You cannot change the position of the staple. If necessary, reformat your print job from the
software application, or rotate your print job using the printer driver to avoid stapled sets that
are difficult to read.
To Next Page
Loading...
