Changing printer settings
78
Infrared Menu
Use the Infrared Menu to change settings affecting jobs sent to the printer through the
infrared interface port. The Infrared Menu is only displayed if a tri-port card is installed.
Job Buffering
Note:
Job Buffering is only
displayed when a formatted
hard disk option is installed, is
neither defective, Read/Write
nor Write protected, and when
Job Buffer Size is not set to
Disabled.
= Off*
= On
Job Buffering temporarily stores jobs on a hard disk option
before being printed, usually freeing the host computer while
the job prints.
If
61 Defective Disk
appears when the printer is turned on, or
during disk format and write operations, refer to the
User’s
Reference
for more information.
If Job Buffering is set to On, print jobs are buffered to the hard
disk option. If Job Buffering is set to Off, print jobs are not
buffered.
Note:
Changing the Job Buffering setting automatically resets
the printer.
Network
x
Setup Values for this menu item are supplied by the specific network
card. Open the menu to see the available values.
Refer to the documentation on the
Drivers, MarkVision and
Utilities
CD for more details.
Infrared Menu
Menu item Printer setting
Infrared Port = Disabled*
= IR Option
x
Select IR Option x to activate the infrared port on the tri-port
card.
If you select Disabled, all of the other menu items in the Infrared
Menu are not available.
* Factory default
Network Menu (continued)
Menu item Printer setting
* Factory default
To Next Page
Loading...
