Changing printer settings
75
Data Bits = 7
= 8*
This setting lets you specify the number of data bits that are
sent in each transmission frame.
Refer to the
Technical Reference
for more information about
data bits.
Parity = Even
= Odd
= None*
= Ignore
This setting lets you select the parity for serial input and output
data frames.
Refer to the
Technical Reference
for more information about
parity.
Honor DSR = Off*
= On
Honor DSR determines whether the printer uses the Data Set
Ready (DSR) signal. DSR is one of the handshaking signals for
most serial interface cables. If Honor DSR is set to Off, data
received by the serial interface is seen as valid data. If Honor
DSR is set to On, only data received while the DSR signal is in
high condition is treated as valid data.
The serial interface uses DSR to distinguish data sent by the
computer from data created by electrical noise in the serial
cable. This electrical noise can cause stray characters to print.
Set Honor DSR to On to prevent stray characters from printing.
Serial Menu (continued)
Menu item Printer setting
* Factory default
To Next Page
Loading...
