Changing printer settings
89
Fax Parity = Even
= Odd
= None*
= Ignore
This setting lets you select the parity for fax data frames.
Refer to the
Technical Reference
for more information about
parity.
Fax Buffer = Disabled
= Auto*
= 105K to maximum size allowed
You can configure the size of the fax buffer to meet the
requirements of your system. If the limited size of the input
buffer is preventing you from receiving fax data, you may want
to increase the fax buffer size.
The maximum size depends on the amount of memory in your
printer, the size of the other link buffers, and whether the
Resource Save setting is set to On or Off. To maximize the
range for the Fax Buffer size, you can disable or reduce the size
of the parallel, network, infrared, LocalTalk, and USB buffers.
Choose Auto to let the printer calculate a buffer size propor-
tional to the total amount of available printer memory. In most
cases, Auto is the recommended setting.
Note:
Changing the Fax Buffer setting automatically resets the
printer.
Job Buffering
Note:
Job Buffering is only
displayed when a hard disk
option is installed, is neither
defective nor Read/Write or
Write protected, and when Job
Buffer Size is not set to
Disabled.
= Off*
= On
Job Buffering temporarily stores jobs on a hard disk option
before being printed, usually freeing the host computer while
the job prints.
If
61 Defective Disk
appears when the printer is turned on, or
during disk format and write operations, refer to the
User’s
Reference
for more information.
If Job Buffering is set to On, print jobs are buffered to the hard
disk option. If Job Buffering is set to Off, print jobs are not
buffered.
Note:
Changing the Job Buffering setting automatically resets
the printer.
Fax Menu (continued)
Menu item Printer setting
* Factory default
To Next Page
Loading...
