Repair information 4-27
7011-2xx / 3xx
Input sensor #1 removal
1. Remove the right side cover. See “Right side cover removal” on page 4-7 for more information.
2. Disconnect the sensor cable at J17 on the controller card (front, near top of card).
3. Carefully place the MFP on its back.
4. Using a small shank screwdriver, remove the screw (A) behind the ACM (auto compensator) pivot that
holds the paper sensor in place.
5. Remove the sensor and the attached cable, flag, and spring.
6. Re-install the sensor so that the flag is spring loaded against the pages as it advances in its path.
7. Verify the cable is captured and out of the paper path.
To Next Page
Loading...
