Repair information 4-47
7011-2xx / 3xx
3. Lift the ADF unit up and away from the flatbed.
Note: The scanner registration must be set after replacing the ADF assembly. See “Scanner Manual
Registration” on page 3-20.
ADF cable removal
1. Remove ADF. See “ADF assembly removal” on page 4-46.
2. Disconnect the ADF cable from J2 on the controller board.
3. Remove flatbed. See “Flatbed removal” on page 4-48.
4. Route the ADF cable through the flatbed assembly. (Art Here)
To Next Page
Loading...
