3-18 Service Manual
7011-2xx / 3xx
Reports
Menu setting’s Page
Print the menu setting’s pages to list the customer setting’s and to verify printer options are installed correctly. It
is helpful to print the customer setting’s before you restore factory defaults or make major changes.
To print the menu setting’s:
1. Select Reports from the Config Menu, and press Select ().
2. Select Menu setting’s Page, and press Select ().
Event Log
Lets the system support person print a limited set of the information contained in the Diagnostics Menu version
of the printed Event Log. For a sample of a printout, see “Event Log” on page 3-10. The limited Configuration
log and the full Diagnostics log printed versions show the same operator panel messages when they print and
follow the same layout guidelines.
To print the event log:
1. Select Reports from the Config Menu, and press Select ().
2. Select Print Log, and press Select ( ) to begin printing the log.
Panel Menus
Lets the system support person enable or disable the operator panel menus. Selecting On (the default) allows
users to change values for the printer. Off disables the users’ access to menus. If a user presses Menu ( ),
they receive a message that the panel menus are locked. When set to Off, this setting restricts all menu access,
even to menus or items set for PIN access. However, when set to On, all PIN restrictions are in restored.
This menu item appears only when the PJL PASSWORD Environment variable is set to 0.
Demo Mode
Lets marketing personnel or merchandisers demonstrate the printer to potential customers by printing the demo
page.
Selections include Deactivate (default) and Activate. Select Deactivate to turn Demo Mode off; or select
Activate to turn Demo Mode on.
Factory defaults
Sets the majority of printer values back to their factory default setting’s.
Warning: This selection cannot be reversed, so this operation should be used only as a last resort to fix any
printer problem. When factory default setting’s are restored:
• All downloaded resources (fonts, macros, symbol sets) in the printer memory (RAM) are deleted.
• All menu setting’s return to the factory default setting except:
– The Display Language setting in the Setup Menu.
– All setting’s in the Parallel Menu, Serial Menu, Network Menu, Infrared Menu, Local Talk Menu, and
USB Menu.
To print current menu setting’s:
To Next Page
Loading...
