Repair information 4-29
7011-2xx / 3xx
LVPS/HVPS card assembly removal
Note: If you are installing a new power supply for an X203 with a serial number of 5920000 or less, or an X204
with a serial number of 5920000 or less, you will also need to install a new controller board. See “Controller
card removal” on page 4-13. X203 / X204 machines with a serial number greater than 5920000 use power
supply 40X6009 (110V)) / 40X6010 (220V).
1. Remove the cover extender (if installed), paper tray,
2. Remove the right cover. See “Right side cover removal” on page 4-7.
3. Remove the left cover. See “Left side cover removal” on page 4-4.
4. Remove the rear cover. See “Rear cover removal” on page 4-5 for more information.
5. Remove two screws (A), one left of the power switch and the other at the opposite side of the panel.
6. Place the MFP onto its back with the rear and bottom of the MFP in view.
7. Remove the screws (B) securing the two foot brackets.
To Next Page
Loading...
