Lexmark XC9235 - Page 107

Menu item Description
Print Page Borders
O*
On
Place a border around each image when printing multiple pages on a single
page.
Collate
O
[1,1,1,2,2,2]
On [1,2,1,2,1,2]*
Print multiple copies in sequence.
Oset Pages
None*
Between Copies
Between Jobs
Oset the output of each print job or each copy of a print job.
Notes:
• Between Copies osets each copy of a print job if Collate is set to On
[1,2,1,2,1,2]. If Collate is set to O [1,1,1,2,2,2], then each set of printed pages
is
oset,
such as all page 1s and all page 2s.
• Between Jobs sets the same oset position for the entire print job
regardless of the number of copies printed.
• This menu item appears only when a finisher is installed.
Staple
O*
1 staple, top left corner
2 staples, left
1 staple, top right corner
2 staples, top
1 staple, bottom left corner
2 staples, bottom
1 staple, bottom right corner
2 staples, right
Specify the staple position for all print jobs.
Note: This menu item appears only when a staple finisher is installed.
Punch
O*
2 holes
3 holes
Set the punch mode for all print jobs.
Note: This menu item appears only when a staple, hole punch
finisher
or a
booklet
finisher
is installed.
“Copy from” Size
[List of paper sizes]
Set the paper size of the original document.
Note: Letter is the U.S. factory default setting. A4 is the international factory
default setting.
“Copy to” Source
Tray [x] (1*)
Multipurpose Feeder
Auto Size Match
Specify the paper source for the copy job.
Tem peratur e
‑4 to 4 (0*)
Specify whether to generate a cooler or warmer output.
Darkness
1 to 9 (5*)
Adjust the darkness of the scanned image.
Number of Copies
1–9999 (1*)
Specify the number of copies.
Note: An asterisk (*) next to a value indicates the factory default setting.
Understanding the printer menus 107