7 Unpack the optional card.
Warning—Potential Damage: Avoid touching the connection points along the edge of the card.
8 Push the card firmly into place.
Note: The entire length of the connector on the card must touch and be flush against the controller
board.
Warning—Potential Damage: Improper installation of the card may cause damage to the card and the
controller board.
9 Attach the shield, and then attach the access cover.
10 Attach the connector cover.
11 If you removed a filter cover, then attach the cover.
12 Connect the power cord to the electrical outlet, and then turn on the printer.
CAUTION—POTENTIAL INJURY: To avoid the risk of fire or electrical shock, connect the power cord
to an appropriately rated and properly grounded electrical outlet that is near the product and easily
accessible.
Upgrading and migrating 281
To Next Page
Loading...
Need help?
General
