Without an optional finisher With an optional finisher
One‑sided printing One‑sided printing
Two‑sided printing Two‑sided printing
One‑sided printing One‑sided printing
Two‑sided printing Two‑sided printing
• Load pre‑punched paper with the holes toward the front or left side of the tray.
• Do not slide paper into the tray.
• To avoid paper jams, make sure that the stack height is below the maximum paper
fill
indicator.
5 Insert the tray.
If loading a paper type other than plain, from the control panel, set the paper size and paper type to match
the paper loaded.
Loading paper and specialty media 33
To Next Page
Loading...
