Lexus GS350 - Programming an Entry Gate; Programming Other Devices; Reprogramming a Button

596
GS350_OM_OM30D41U_(U)
5-7. Other interior features
Press and hold the vehicle’s programmed HomeLink
®
button for 2
seconds and release it. Repeat this step once again. The garage door
may open.
If the garage door opens, the programming process is complete. If the door
does not open, press and release the button a third time. This third press and
release will complete the programming process by opening the garage door.
The ceiling mounted garage door opener motor should now recognize the
HomeLink
®
signal and operate the garage door.
Repeat the steps above to program another rolling code system for
any of the remaining HomeLink
®
buttons.
■ Programming an entry gate (for U.S.A. owners)/Programming a
devices in the Canadian market
Place the remote control transmitter 1 to 3 in. (25 to 75 mm) away
from the HomeLink
®
buttons.
Keep the HomeLink
®
indicator light in view while programming.
Press and hold the selected HomeLink
®
button.
Repeatedly press and release (cycle) the remote control transmitter
for 2 seconds each until step is completed.
When the HomeLink
®
indicator light starts to flash rapidly, release
the buttons.
Test the HomeLink
®
operation by pressing the newly programmed
button. Check to see if the gate/device operates correctly.
Repeat the steps above to program another device for any of the
remaining HomeLink
®
buttons.
■ Programming other devices
To program other devices such as home security systems, home door
locks and lighting, contact your Lexus dealer for assistance.
■ Reprogramming a button
The individual HomeLink
®
buttons cannot be erased but can be repro-
grammed. To reprogram a button, follow the “Reprogramming a
HomeLink
®
button” instructions.
3
4
1
2
3
4
4
5
6