DCC FUSE INSTALLATION DURING PDS – PD066-06 September 22, 2006
Page 2 of 2
3. With the ignition switch OFF, install the DCC fuses in their original locations in the
engine compartment fuse block.
Remove
These DCC
Fuses
Fuse Block Cover
Fuse Block
Install DCC
Fuses Here
Fuse Block
NOTE:
S The procedure above is necessary to perform the VGRS initialization correctly.
S While the vehicle is stored at the dealership, disconnect the negative (–)
battery terminal to prevent battery discharge. Refer to TSIB No. PG001-06,
“Battery Maintenance for In-Stock Vehicles & Pre-Delivery,”
for battery
maintenance information.
4. Replace the engine compartment side cover. Installation is in the reverse order
of removal.
When inserting the clips, refer to the illustration.
Installation
Procedure
(Continued)
To Next Page
Loading...
