Lexus Supports ASE Certification
Page 1 of 2
Title:
FRONT LICENSE PLATE MOUNTING
BRACKET & LICENSE PLATE
INSTALLATION
Models:
’07 LS 460
Technical Service
Information Bulletin
September 22, 2006
PD069-06
The front license plate mounting bracket and two self-tapping screws for the 2007
model year LS 460 are placed in the luggage compartment of the vehicle at the
assembly plant. For states that require a front license plate, install the bracket and
bolts on the bumper cover during Pre-Delivery Service (PDS) according to the
following procedures.
S 2007 model year LS 460 vehicles.
OP CODE DESCRIPTION TIME OFP T1 T2
N/A Not Applicable to Warranty – – – –
1. Align holes “A” of the mounting
bracket with the dimples on the front
bumper cover. Mark the location of
holes “B” on the front bumper cover.
NOTE:
S Holes “A” are used to install the
mounting bracket to the bumper cover.
S Holes “B” are used for installation of
the front license plate to the
mounting bracket.
2. Drill two relief holes with a diameter of
11 mm (0.43 in.) at the marks on the
front bumper cover (holes “B”
location) to prevent the license plate
retaining bolt ends from contacting
the cover.
NOTE:
Do NOT drill into the dimples on the
front bumper cover.
PRE-DELIVERY SERVICE
Introduction
Applicable
Vehicles
Warranty
Information
Dimples
Mark and Drill Holes
Mounting
Bracket
Mounting Bracket
A
B
A
B
Installation
Procedure
To Next Page
Loading...
